Armmite F4: programming the firmware


Author Message
matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 2995
Posted: 08:35am 24 May 2019      

  Quote  Excuse my ignorance, lack of understanding etc but how do you get the LCD Panel to go?
Is there a backlight connection required?


It should just work, there is no configuration needed. If you reset the options then just use: OPTION LCDPANEL ILI9341_16,orientation

The backlight is automatically controlled using a 1KHz PWM signal. Use the BACKLIGHT command to control it (0-100)

Touch is also pre-configured and pre-calibrated but you may need to calibrate again if it doesn't seem very accurate on your screen.