Armmite F4: programming the firmware


Author Message
seco61
Senior Member

Joined: 15/06/2011
Location: Australia
Posts: 205
Posted: 12:41am 25 May 2019      

My 5 units arrived today (took about 5 weeks to arrive...).

When I first attempted to power it up, I got a USB descriptor error

I then looked closely at the USB cable supplied with the unit and could see that one of the pins in the mini-usb end looked "wrong". So used one of my own "known to be good" expensive mini-usb cables and all worked perfectly.

I did do the GUI CALIBRATE as the default setup was off by around 2mm.

This sure is a nice little platform to work with!

Thanks Peter!Edited by seco61 2019-05-26

Regards

Gerard (vk3cg/vk3grs)