driving via canbus Eltek 2kW Flatpack2 supplies


Author Message
poida

Guru

Joined: 02/02/2017
Location: Australia
Posts: 1117
Posted: 09:53am 23 Nov 2020      

Wiseguy sent me a PCB connector.
The one shown in your post is probably the same sort of thing.

the 3 pins for canbus are sort of isolated.
When using them, the ground needs to be tied to output negative.
And the canbus transciever needs to terminate can-hi and can-low
with a resistor. There seems not to be any termination resistor within
the Eltek's canbus outputs.