 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : Micromite MMBasic possible on these chips ??
| Author | Message | ||||
| athlon1900 Regular Member  Joined: 10/10/2019 Location: AustriaPosts: 48 |
Hello @all , i found these chip-familiy on digikey. Can mmbasic run on these chips? PIC32MX1XX/2XX/5XX 64/100-PIN FAMILY nice greetings to everyone |
||||
| matherp Guru  Joined: 11/12/2012 Location: United KingdomPosts: 8592 |
Not as-is but why would you? These chips are poor relations of the MX470 which is fully supported by Geoff and has the same footprint(s) |
||||
| athlon1900 Regular Member Joined: 10/10/2019 Location: AustriaPosts: 48 |
Hi Peter , thanks for your answer. I have a project that is a little tight with the 44-pin and for that I would need a port expander, like the MCP23017 or MCP23S17. I would have been interested in the 64-pin chip and the internal 50Mhz would be enough. As few components as possible should also be used, i.e. no quartz and as few capacitors as possible. --> cost reduction 44-pin PIC32MX170F256D-50I/PT --> € 5,12 --> port expander needed 64-pin PIC32MX170F512H-50I/PT --> € 6,68 --> fits as is 64-pin PIC32MX470F512H-120/PT --> € 8,10 --> quarz needed |
||||
 Print this page |
