Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : Some help with ......PORT ......
Author | Message | ||||
hitsware Guru Joined: 23/11/2012 Location: United StatesPosts: 535 |
Color Maximite w/ver. 4.5 for x= 1 to 3
port (1,2)=x next x I get "invalid output pin" error I tried Setpin 1, dout:Setpin 2, dout Still no go ????? |
||||
TassyJim Guru Joined: 07/08/2011 Location: AustraliaPosts: 5915 |
A bug. See previous post: http://www.thebackshed.com/forum/forum_posts.asp?TID=6772&PN =4 We will have to wait for Geoff to finish his travels. Jim VK7JH MMedit MMBasic Help |
||||
hitsware Guru Joined: 23/11/2012 Location: United StatesPosts: 535 |
Gracias ! .... I remember reading that now ............ |
||||
hitsware Guru Joined: 23/11/2012 Location: United StatesPosts: 535 |
Would this bug be on a pre-programmed MicroMite ? |
||||
JohnS Guru Joined: 18/11/2011 Location: United KingdomPosts: 3669 |
Depends which version of MMBasic - see the thread mentioned. John |
||||
hitsware Guru Joined: 23/11/2012 Location: United StatesPosts: 535 |
http://geoffg.net/Downloads/Micromite/Micromite_Firmware.zip http://geoffg.net/Downloads/Maximite/Colour_Maximite_MMBasic .zip Just outta curiousity: As long as the version is 4.5, any bug in one will be in the other ? |
||||
TassyJim Guru Joined: 07/08/2011 Location: AustraliaPosts: 5915 |
A lot of the new code was developed for the micromite and then added to the maximite code afterwards They were developed separately so bugs can be in one but not the other. I think the PORT command is OK on the micromite and OK on maximite V4.4 Jim VK7JH MMedit MMBasic Help |
||||
Print this page |