Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : VT100 "MODE NOT SUPPORTED"
Author | Message | ||||
hitsware Guru Joined: 23/11/2012 Location: United StatesPosts: 535 |
I got a VT100 board together. When plugged into VGA monitor (with or without MicroMite), I get "mode not supported" on the screen. At first I thought it was a message from the board, but now I'm thinking it's from the monitor itself .... Ideas ????? |
||||
TassyJim Guru Joined: 07/08/2011 Location: AustraliaPosts: 5913 |
The monitor doesn't like the scan rate that the VT100 terminal uses. Some monitors only accept a limited range of scan rates. Jim VK7JH MMedit MMBasic Help |
||||
hitsware Guru Joined: 23/11/2012 Location: United StatesPosts: 535 |
Hmmmmmmmmmmmm..... I don't have the jack for composite yet. Might that still work ? |
||||
hitsware Guru Joined: 23/11/2012 Location: United StatesPosts: 535 |
After adding the solder blob for VGA signal and the LED, the VT100 works (loopback and all) Still cannot reach the MicroMite though. It's intermittent at best. Best case I get the Basic splash screen, but keyboard doesn't echo. At times keyboard echos, but certain keys give weird results ........ Gettin' closer ............. |
||||
Print this page |