 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : DHCP Ethernet device
  Page 2 of 2 |
|||||
| Author | Message | ||||
atmega8 Guru  Joined: 19/11/2013 Location: GermanyPosts: 712 |
Bigmik, REALLY PERFECT would be this Device, with an Openwrt Linux Image on it. With WIFI, Rj45, RS232 and the complete World of Linux ( shell etc.) is open for you. No limits to the limits of your Imagination;-) Linux  |
||||
| atmega8 Guru Joined: 19/11/2013 Location: GermanyPosts: 712 |
Or this very nice device: Vcore But with casing about 50$$... |
||||
jman Guru Joined: 12/06/2011 Location: New ZealandPosts: 711 |
Hi Attached is some code from the PicBasic forum that implement's DHCP on the W5100/ I have not had an in depth look at the code but I ma sure it will give you some pointers. Regards Jman2017-04-17_021556_w5100-dhcp-demo.zip |
||||
bigmik Guru Joined: 20/06/2011 Location: AustraliaPosts: 2870 |
Hi JMan, All, @JMan, Thanks for that, it looks readable (sort of) but boy it is a heap of code to digest.. I am currently exploring the possibility of using a Static IP address, (actually a range of static IP addresses to select from) or at worst case enter one in on power-up. I have asked the question to see if there is an IP address that is un-allocated that I can permanently use, but as the system hasnt yet been installed that information probably is, at this stage, unobtainable. I figure we can do a WSPING from the main control room end and find an IP that hasnt been allocated and adopt that at worst case.. So it is still a possible route to go with. Kind Regards, Mick Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<< |
||||
| Page 2 of 2 |
|||||
 Print this page |
