Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 13:56 19 May 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Matherp Navigation PCB

Author Message
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1805
Posted: 07:58pm 31 May 2017
Copy link to clipboard 
Print this post

Just a small error on Matherp's excellent Navigation PCB. The screen printing on the back has 'Option Touch 19, 7' this should be 'option Touch 19, 17'. Maybe this has been referred to in his post but I couldn't see anything. Setting the wrong pins causes the terminal screen to scroll with Error: Touch Not Calibrated and the only way to fix it is to re flash the chip. (as I found out 3 times)
Paul.
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
Bill7300
Senior Member

Joined: 05/08/2014
Location: Australia
Posts: 158
Posted: 07:37pm 03 Jun 2017
Copy link to clipboard 
Print this post

Have any of our usual "suspects" added Peter's Navigation PCB to their stock lists? I have been watching for any announcements but may well have missed it.
Bill
 
palcal

Guru

Joined: 12/10/2011
Location: Australia
Posts: 1805
Posted: 07:41pm 03 Jun 2017
Copy link to clipboard 
Print this post

I got mine from WW, flick him a PM.
Paul
"It is better to be ignorant and ask a stupid question than to be plain Stupid and not ask at all"
 
Bill7300
Senior Member

Joined: 05/08/2014
Location: Australia
Posts: 158
Posted: 08:24pm 03 Jun 2017
Copy link to clipboard 
Print this post

Thanks Paul. Will do.
Bill
Bill
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024