Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 07:37 29 Mar 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Inverter issues

     Page 2 of 2    
Author Message
DaveP68

Senior Member

Joined: 25/11/2014
Location: New Zealand
Posts: 292
Posted: 08:14am 13 Jun 2018
Copy link to clipboard 
Print this post

I can't remember the exact value wasn't my inverter. The zener could have been 5.6 Volts 200 mW surface mount. Would need to know the resistor divider ratio on the A to D input which I didn't record to confirm.

Without a circuit diagram I just traced the parts to work out how to do it on the day.
There are realities if you do not accept, will lead to frustration because you will be spending time on wrong assumptions and the results cannot follow! The Dunning Kruger Effect :)
 
     Page 2 of 2    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024