Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 16:07 29 Mar 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : LENZ2 WING DIMMENSIONS

Author Message
Nacho
Newbie

Joined: 12/01/2019
Location: Spain
Posts: 4
Posted: 03:07pm 03 Jun 2019
Copy link to clipboard 
Print this post

Hello,

I much appreciate if you could help me clarify Ed Lenz wing dimmensions.
According to his published information -see attached picture-

- Wing Width (¿Diameter or Radii?) = Turbine Diameter x 0,1875
- Wing Chord = Turbine Diameter x 0,4

Ed Lenz shows ¿R (Radii)? = 3.38 for a 3 ft Turbine Diameter as an example in the same document. See second image.

If Wing Width = 0,1875 x Turbine Diameter, then
3 ft x 12 inches/ft x 0,1875 = 6,75 inches (3,38 x 2)
which seems diameter nor radii...

Please:
- Are that formulae adimensional? In inches?
- Any formulae in metrics?
- Is the Wing Width the wing diameter or the wing radii?

Thanks,









Edited by Nacho 2019-06-05
 
Boppa
Guru

Joined: 08/11/2016
Location: Australia
Posts: 814
Posted: 02:00am 04 Jun 2019
Copy link to clipboard 
Print this post

His measurements are in inches

Lenz2 turbine

This picture (from that site) might help you visualise it better




ETA
HERES a inch to metric converter just select 'decimal inches' from the tabs up the top, to mm and plug in his inches numbers

eg 0.50 inches (the size of the three slots) is 12.7mmEdited by Boppa 2019-06-05
 
Nacho
Newbie

Joined: 12/01/2019
Location: Spain
Posts: 4
Posted: 07:44am 23 Jun 2019
Copy link to clipboard 
Print this post

Thanks Boppa.
Is the Wing Width the wing diameter or the wing radius?
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024