Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.
|
Forum Index : Microcontroller and PC projects : Pico Lipo Issues
Page 2 of 2 | |||||
Author | Message | ||||
pwillard Senior Member Joined: 07/06/2022 Location: United StatesPosts: 274 |
I believe it is due to MMCC's (justified) expectation that there is no delay between ">" prompts. When a "NEW" command is issued, which MMCC does before sending "AUTOSAVE", the result is that MMCC will "timeout" and give up. But to be clear... the DELAY with ">" prompt is specific to the PicoLipo for some reason. Edited 2022-08-31 00:00 by pwillard |
||||
matherp Guru Joined: 11/12/2012 Location: United KingdomPosts: 8592 |
Please try the attached with teraterm (any other terminal problem is an SEP) NB: will erase all options PicoMite.zip |
||||
Tinine Guru Joined: 30/03/2016 Location: United KingdomPosts: 1646 |
Not to muddy the waters but my preferred method is to select-copy the source and then, at the MMCC prompt, type AUTOSAVE -> Enter, paste the code followed by Ctrl-Z. Subsequently use the UP arrow key to avoid having to retype AUTOSAVE. Edited 2022-08-31 00:40 by Tinine |
||||
pwillard Senior Member Joined: 07/06/2022 Location: United StatesPosts: 274 |
Erase all options... no big deal... this is all experimenting now... Anyway... whatever you did... fixed it. No delays in Teraterm getting a ">" prompt back and MMCC is now behaving again... Issuing a "NEW" command no longer causes the excessive delay in getting back to ">" and additional <CR> are not delayed in getting the prmpt back (as it was before) so the behavior is again matching what is expected. :) Thanks. Edited 2022-08-31 00:49 by pwillard |
||||
Page 2 of 2 |
Print this page |