JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 19:32 06 Jul 2020 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Windmills : Windmill DIY Analog MPPT Circuit

     Page 4 of 4    
Author Message

Joined: 17/10/2014
Location: Netherlands
Posts: 4
Posted: 09:27am 28 Oct 2014
Copy link to clipboard 
Print this post

Hi, I took the liberty of cleaning up the schematics somewhat. I hope it's useful.


Ah, I didn't know it would be resized. Give me some time and I will post a higher resolution image via photobucket or something.Edited by RetepV 2014-10-29

Admin Group

Joined: 05/06/2004
Location: Australia
Posts: 4801
Posted: 11:48am 28 Oct 2014
Copy link to clipboard 
Print this post

If you save and upload as GIF, the forum will resize to 1000 pixels wide instead of 500, as it does for JPG's

GIF's are perfect for circuit diagrams, cad drawings, etc, and are resized to 1000 pixels wide. JPG's are more suitable for photos, and are resized to 500 pixels wide.

People say 2020 is a terrible year, with the bush fires, COVID 19, and riots. But I see it as the year we woke up to ourselves.

JAQ Software

Joined: 15/03/2019
Location: France
Posts: 1
Posted: 12:05pm 15 Mar 2019
Copy link to clipboard 
Print this post


It has been a long time since nobody talked on this topic but I'll try to ask my question anyway.
I am very interested in this setup but I would like to connect it to a grid-tie inverter instead of a battery.

In particular, I have an Enphase M250 (solar micro inverter) that I would like to use on my DIY Wind turbine.

I would like to directly convert the energy towards the grid using the micro-inverter, without using a battery.

As I understand the circuit, the battery is useful in order to provide a reference voltage that is used by the control circuit to generate the correct PWM duty cycle to the boost inverter and thus the optimal DC voltage to the windmill for optimal power production.

Would this circuit still work by connecting an inverter at the output instead of a battery?

The M250 inverter has a DC in voltage range from 16V to 48V, but unlike a battery it does not provide a constant reference voltage at its input. Instead, it varies the voltage in order to find the MPP.

I already tried connecting my generator directly to the micro inverter input using only a rectifier in between, this works but the micro inverter places itself at its minimum voltage point (16V) and draws the available current.
However, it is not guaranteed that it will remain at 16V for higher currents for example. Indeed, I could only produce 2-3A from the generator by turning it by hand, just for testing, because my windmill is not ready yet. I will use a hubmotor from an electric bike, so I could already test the behavior by connecting the motor output to the inverter and pedaling manually on the bike to generate electricity.

Maybe an additional circuit would be required between the ouput of the circuit presented here and the micro inverter ? At some point in the discussion it was said that people who would need to reach a higher DC voltage at the generator than at the battery could use an additional buck converter... Maybe adding such a converter could work, by providing a constant voltage to the inverter but preventing it from varying the voltage at the output of the circuit ?

Thank you very much for your help!

Edited by jm1010 2019-03-16
     Page 4 of 4    
Print this page

To reply to this topic, you need to log in.

© JAQ Software 2020