Home
JAQForum Ver 20.06
Log In or Join  
Active Topics
Local Time 12:18 29 Apr 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : [Micromite]I2C LCD Library

     Page 3 of 3    
Author Message
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2870
Posted: 10:18pm 23 Mar 2024
Copy link to clipboard 
Print this post

Hi Steven,

Welcome to the group.

This is a 10 year old library post.

On the surface I would have thought there is nothing to stop the library working on a 64 pinner as from memory you assigned the pins you wanted to use.

Sadly Peter Carnegie has left The BackShed and I haven’t been able to contact him for many years now.

I am not great with programming but I am sure that someone on here would be able to look at the libraries to see if there is some glaring thing that would stop the 64 pin chip from working with it.


Kind Regards,

Mick (the big one)





.
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
sgregory
Newbie

Joined: 10/03/2024
Location: United States
Posts: 4
Posted: 10:26pm 23 Mar 2024
Copy link to clipboard 
Print this post

Turns out the Micromite Plus (64 Pin) requires the all PAUSE commands to be used.
Edited 2024-03-24 08:26 by sgregory
 
sgregory
Newbie

Joined: 10/03/2024
Location: United States
Posts: 4
Posted: 10:57pm 23 Mar 2024
Copy link to clipboard 
Print this post

Hello Mick,

I was using the latest library, but it turns out the PAUSE command that were commented out are required.  I assume the faster micro was out running the controller.

Thanks!
 
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2870
Posted: 05:39am 24 Mar 2024
Copy link to clipboard 
Print this post

Hi Steven,

Sounds logical,

I assume you have it working for you now?

I haven't looked at the library file for several years so I am more rusty than I am with other programming stuff.

Kind Regards,

Mick.




.
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
Chopperp

Guru

Joined: 03/01/2018
Location: Australia
Posts: 1032
Posted: 11:54am 24 Mar 2024
Copy link to clipboard 
Print this post

  bigmik said  This is a 10 year old library post.
Mick (the big one)
.

And Mick (the big one), you don't even look a day older from back then

Brian
ChopperP
 
sgregory
Newbie

Joined: 10/03/2024
Location: United States
Posts: 4
Posted: 12:51am 25 Mar 2024
Copy link to clipboard 
Print this post

Mick,

Yes, it's working fine now.

Thanks!
 
     Page 3 of 3    
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024