H743Zi2 Board


Author Message
KeepIS

Guru

Joined: 13/10/2014
Location: Australia
Posts: 715
Posted: 09:31pm 27 Jun 2019      

That works perfectly at 400Mhz on the V2 board.

If I set CPU to 480Mhz - the correct speed for the V2 board - it works on a reset but not on power up, obviously comes back to timing and I assume your parameter list will include something like that? or can you simply take the option CPU speed parameter and set it from that?

I assume that "both" PD10 and PG6 will now be unavailable (mm.info$ = Invalid) as IO pins?

Thanks again for the support and help with these ARM MM.BASIC ports.
It's all too hard.