Guru
Joined: 20/06/2011
Location: AustraliaPosts: 2981
| Posted: 02:14am 09 Sep 2019 |
@Brian,
Actually, (Yes I know you were joking), I almost couldn't find it in its plastic bag.. It is a whopping 3.2mm x 2.5mm and was darn hard to solder some wires on to test it in my X144 board. (yes it works fine even without the pin 1 mod).
This might be a challenge for someone to solder but then the 0.5mm pitch on the MZ is not going to be for home handyman solderers either. Flux will be a must.
Here is a rough as guts picture next to a 0.1" shorting link
Kind Regards,
Mick
EDIT !!!
Wow! Look at the size the image came out as..
Edited 2019-09-09 12:16 by bigmik
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<