Senior Member
Joined: 21/01/2011
Location: AustraliaPosts: 282
| Posted: 12:03pm 22 Dec 2021 |
Pico inverter problems
Good day all ,
I have been able to upload the nano program
nano_1_v7_no_bessel.ino.zip the sketch verified and loaded with out error
and generates a 15v pulsed out put to the IR2184 chips on pin 4.
As this is a earlier nano program will it still run the pico inverter controller?
The reason I ask is that I can not verify and upload the later firmware
pico_2_heavy_filter_bv.ino.zip and pico_1.ino.zip with out a error notice.
As I do not know how to save these error messages to post,
for that matter I know almost zero about arduino nano.
I am using Arduino version 1.8.16 may be this is the fault?
Any advice will be most appreciated .
Cheers john