Senior Member
Joined: 21/01/2011
Location: AustraliaPosts: 282
| Posted: 10:26am 23 Dec 2021 |
Good Day, Angelo and Peter,thanks you both for the help.
poida said,,,
a trap:
if there are two copies of the .ino file in the directory
and you double click to load one of them
you will find it will not compile.
Delete the extra file and try again.
Problem 1 done that!!
The Arduino IDE needs the .ino file to be inside a directory named the same.
eg:
a folder named "pico_2_heavy_filter_bv" is to contain a file named
"pico_2_heavy_filter_bv.ino"
Problem also done that !!
After much trial and error Firmware compiles and loads and the controller tested ready,
and after xmas, I will fit to my repaired inverter.
Many Thanks and best wishes to all for Xmas.
cheers john