Guru
Joined: 02/02/2017
Location: AustraliaPosts: 1459
| Posted: 07:32am 16 May 2021 |
Power board is completed.
It is compatible with the nanoverter and the soon to come picoverter
and Madness's control board.
In other words it uses the 10 pin IDC connector we have used for years.
(It even is compatible with Powerjack LF inverters too)
Make sure you specify 2oz copper.
I like and use all the time EasyEDA.
The gerber files:
Gerber_PCB_madboard 24.5mm v4.zip
and this is what it looks like:
PCB_PCB_madboard 24.5mm v4_2021-05-16-1.pdf
I fixed a few things:
TIP35C
the high side TIP41/42 were swapped.
The 18V zener was wrong.
And the base pins for all 4 totem poles now have 10K pull down to keep then
shut-the-hell-off during boot.
Have fun and build a few and blow them up and sh!t..