Some G scale Railway Stuff

Author	Message
Revlac Guru Joined: 31/12/2016 Location: Australia Posts: 1151	Posted: 12:41pm 26 Oct 2022       Made a Brake cylinder for under the carriages to ad a little detail. Very handy to have real one on hand as an example. It was fun to make this using Scad and can be added to if needed. This is printed with a .2mm nozzle, easy to clean up the support material, I did an initial print with a .4mm nozzle and the detail is not as good but usable, however the support material was a real PITA to remove and clean up the model, worked out faster overall to use the .2mm nozzle this time.       The photo is blown up to get a full frame, the model in the picture is only 32mm long. Scad and STL Brake cylinder.zip