HardingJohn
 Regular Member
 Joined: 28/07/2017 Location: AustraliaPosts: 78 |
Posted: 11:41am 13 Jan 2022 |
|
|
|
Thanks Peter. I am lucky in that I had purchased a few STM32H743VIT6U chips. These are the newer ver V 480Mhz. I just could not get the 5.07b0016 to run on it. I think it was because I was using Stlink V2. I will change to using the USB port on the chip to load your latest H7 version and see if that works.
The WeAct board I asked about uses this same chip and they appear to have stock. It would be quite a useful little board. Would need some pin assignment to suit the 0.96 inch display and camera port. Would you be able to have a quick look and see if it would take a lot of work or not.
Thanks again. |