Warpinverter Build


Author Message
rogerdw
Guru

Joined: 22/10/2019
Location: Australia
Posts: 818
Posted: 10:09pm 07 Jun 2023      

Wow, that looks so good. I thought for a minute that you'd put new short caps in  ...  but then realised it was the spacer/holder that made it look like that. Viewing pix on mobile is pretty hard, will have to inspect again on the PC.

What value resistance did you choose for the precharge and for the discharge resistors?

Edit:

Now I've had a closer look on my pc and am wondering what the small pcb is on the cap steady board (in the first photo)? I originally thought it was the control board but it looks different and you say you're going to fit that above.

What size DC switch are you using?
Edited 2023-06-08 09:26 by rogerdw