Regular Member
Joined: 04/04/2021
Location: AustraliaPosts: 63
| Posted: 01:27pm 09 Jun 2023 |
Yes that is Klaus's board which also included the hall effect sensor mod for output voltage control.
I have had it running without the caps in place and have the transformer phasing all sorted. Hopefully I get some time this weekend for testing. I also need to take some measurements at the test points on your board Klaus and get that setup correctly.
Roger the resistors are both 150ohms, mainly because I ordered a couple when I worked out my pre charging and that worked well for a good discharge value. Do you mean the DC breaker on the side or the contactor? I will have to check the breaker as I can't remember off the top of my head. The contactor is one of these Link
Edited 2023-06-09 23:28 by Alston