Guru
Joined: 05/10/2019
Location: United KingdomPosts: 5052
| Posted: 10:41am 24 Sep 2022 |
You can just squeeze a standard Pico onto a 50mm PCB (but you have to cheat by letting the Pico overhang slightly at the ends). Of course, you can always saw off the bottom end from a standard Pico if you want a few less pins. It's cheaper than buying a pre-crippled one and still works. :) I wouldn't want to go SMD 'cos it's hard when your eyes are c**p and your hands shake.
EDIT:
See here.. If you don't want buttons & switches it will run on a Pimorini Tiny 2040 (here) glued onto a SD card. Not bad for a CP/M machine. :)
Edited 2022-09-24 21:31 by Mixtel90