Guru
Joined: 22/02/2006
Location: AustraliaPosts: 1395
| Posted: 08:55am 03 Jun 2023 |
OK Guy's the grey matter is starting to clear and all I need to finish the component list is a few caps and the fet drivers.
With these 360 amp fets I'm going to go 3 each leg just so I can suck the best out of aerosharp toriod as it is rated at 3Kw but as Mike pinted out when he gave it to me he said just connect the existing windings in parallel.
Those 10,000uf 35 volt caps do look a tad small to me but Roger did say he used them and I am thinking of trimming down the aerosharp heat sinks so they can inwards as that will solve the fan solution.
With my big win on the grey matter over the MTTP it is time to wind this toriod with that 6.5x5 copper wire and 3 metres going over and getting less each time will be a fun task to do.
Now for the choke for this inverter I used the big choke out of the aerosharp and wound 10 turns on each side and i have looked a Tony's pic that many times I will know how to get it connected in phase.
Cheers Bryan