Bryan's Inverter build

Author	Message
Murphy's friend Guru Joined: 04/10/2019 Location: Australia Posts: 669	Posted: 08:21am 13 Oct 2023         Godoh said   Other than that if the wooden former is cut on a diagonal so it is made up of two wedges then the former can be removed fairly easily. But use insualtion on them to make them slide without damaging the windings Pete Another trick, which I use on my aluminium formers, is to make one end 0.5mm bigger than required. This makes the thing ever so slightly conical and, if you mark the smaller end and knock it out from this end, it'll just pop out after a few mm of knocking.