Bryan's Inverter build


Author Message
Bryan1

Guru

Joined: 22/02/2006
Location: Australia
Posts: 1450
Posted: 06:48am 18 Oct 2023      

G'Day Guy's,
            Well found some scrap 4mm ali plate at work so got on the guilo and cut some pieces 83mm wide 2 off and 50mm wide 2 off. I'm going to cut some 75x50mm RHS and use some countersunk M4 screws hold the ali down. On the 50 mm side I'll use some 0.5mm steel packing to get the 1mm clearance.

This will give me 1mm clearance and I will put a slight taper on to get the secondary off the former easy.

As I do have 2 spools of that 1.6mm may aswell go 2 inhand as the room is there in the E-core for 6 layers and the old saying the more the wire the better.

Cheers Bryan