Bryan's Inverter build


Author Message
Godoh
Guru

Joined: 26/09/2020
Location: Australia
Posts: 479
Posted: 07:30am 18 Oct 2023      

Hi Bryan, you could just use a couple of bits of sticky tape to take the aluminium to the RHS. Then just put some insulation over the aluminium so the wire doesn't get scratched when it is wound on.
If there is not much tape on the aluminium it would make it easier to get the coil off the former.
Just wondering if you know of a reasonably priced supplier of the enamelled wire.
I have been looking and it seems that it is around $100 / kilo, and mostly coming from India.
I am hoping to find about 3 kg of 1.8mm diameter closer to home than India.
Pete