Guru
Joined: 22/02/2006
Location: AustraliaPosts: 1614
| Posted: 06:36am 18 Oct 2025 |
Ok I made a mistake on the Victron voltage as it is set for 29 volts and with the grid tie connected thats the trip point I can set the voltage controlled rely at.
I'm now on planning the layout and writing up a journal of tasks to do so I have a good guide to getting this done.
Now with the LM35 I did notice yonks ago it was externally mounted on a huge heatsink and I did find in my stuff a old computer main chip heatsink with 12 fan attached. Now for mounting that heatsink some 2mm plate can go thru a fin then get bolted to the side of the box. Now it would be nice to monitor the temp of this on the LCD so a question for Poida are there any spare pins on the nano where a a 10K thermister can be hooked up