Guru
Joined: 22/02/2006
Location: AustraliaPosts: 1614
| Posted: 08:06am 05 Nov 2025 |
G'Day Guy's,
Well finally got confirmation from Aussie post this shipment off the slow boat will be here in the morning or the next day
I annealed 2 0ff 400mm hard drawn copper and found a second anneal was needed to get the pipe flat and straight. I have more than enough to do both sides of the board now with VS1 and VS2 the bussbar just needs to clear the board by some so with using 2 of those 4mm mounts for each pad a total of 16 was needed.
I still need to get the M3 spacers so a trip after work on Friday I call into Jaycar and grab them so I can set the base plates for the main power board. Got some 6mm perspex for mounting the brain board.
So slowly getting there and a busy weekend is on the cards.
Regards Bryan