Guru
Joined: 22/02/2006
Location: AustraliaPosts: 1614
| Posted: 07:16am 12 Nov 2025 |
Last weekend I went over to Roger's and he soldered up the Nano and the nano to the board for me was record time
while looking at some of the solder pads I did a close look did show the old IC sockets were tarnished and the solder didn't flow properly. Now I am going to have a close look at the main board and check all the soldering I did just to make sure everything is right.Talking with the sparkie at work today and the talk was on for finding some 35sqmm wire and soon found close to a full roll
then he found 4 off 8mm lugs and did say they had the crimper there so going to 100mm for one end and 350mm for the other end which goes to the main board.So the question was asked to my boss so tomorrow I'm taking the toroids and my inductance meter then thats another major task out of the way.