Guru
Joined: 22/02/2006
Location: AustraliaPosts: 2292
| Posted: 06:20am 10 Apr 2026 |
So if I'm right the problem may be with the VFB so may be back to looking and checking components on the control board VFB section.
It maybe a simple solder joint where the board is double sided and with me soldering the back the solder didn't flow thru to connect the top pad.
Now when I first started the inverter the voltage was around 130 volts off memory and I used the pot on the VFB part of the control board to get a 230AC output.
Well they do say building you're first inverter will get you knowing everything about it but in my case it does seem I am finding EVERY problem there is
