MMEdit V5.2


Author Message
disco4now

Guru

Joined: 18/12/2014
Location: Australia
Posts: 941
Posted: 10:31pm 14 Aug 2024      

Hi Jim,
I think a little bug may have crept in somewhere. I am sure previously I could send a new file from MMEdit via MMCC with a different target and it would connect to the correct device no matter what MMCC was or was not currently connected to.
e.g. my target is 'target port\com5:115200 s\armite
If MMCC is connected to a different device or even disconnected from a previous device then it will disconnected from that device, say its connecting to the new target, but then load to the old target. See below.



If you first clear the box in MMCC that holds a copy of the most recent target then it all works as expected, changes the port and loads to the new target.






Regards
Gerry