Battery problems and LiFePO4

Author	Message
KeepIS Guru Joined: 13/10/2014 Location: Australia Posts: 2232	Posted: 03:20am 16 Jan 2024         Revlac said   checked the setting on the (old) phone app and it looked the same as the usual BMS, settings all over the place and only the balance light on, sounds about right. Most notable was the cell voltages were very stable and not bouncing allover the place, will connect it to the PC later and see how it works out, its just an experiment. I know I mentioned this before, but just a quick FYI: Using the Phone APP, the SOC and current are not displayed (obviously) but the Equilibrium tab (or whatever it's called) is accessing the settings for the A-Balancer, so EQ current, trip voltage and on/off switch all work when connected to the Balancer port. The latest PC SW V2.1.9 that I mentioned previously has the Active Equilibrium tab. I'm not sure if the earlier version had that setup correctly? . Edited 2024-01-16 13:21 by KeepIS