Guru
Joined: 11/02/2018
Location: AustraliaPosts: 3321
| Posted: 05:15am 22 Jan 2024 |
If there aren't too many codes you can record them with an IR receiver and CSub LOG (not tested on latest firmware).
Then use it's output combined with pulses for the 38kHz carrier (13µS high and 13µS low) to construct arrays for DEVICE BITSTREAM. The saved arrays can then drive the IR LED via a transistor.
A short MMBasic program could automate the conversion process.
The output array of CSub LOG is in the form of +timestamps for rising edges and -timestamps for falling edges.
Latest version of LOG
Edited 2024-01-22 15:28 by phil99
Footnote added 2024-01-22 16:31 by phil99
Attempted to use CSub LOG on latest firmware but no-go.
Footnote added 2024-01-23 21:36 by phil99
CSub Log has been recompiled for V5.08.00 by @disco4now and is now working.