Guru
Joined: 21/06/2018
Location: AustraliaPosts: 1191
| Posted: 11:10am 09 Jun 2024 |
It is easier to write than draw the picture. Make a plate of aluminium same size as control PCB
Screw aluminium plate where pcb is now, use spacers to screw the plate to the existing spacers (I hope you have 4 spare spacers female to male).
Now solder 1 and only 10n capacitor on PCB pads just next to J1.
Now screw control PCB onto the spacers sticking up from the aluminium plate.
Put wires/plugs back to control card and retest.
I will draw a picture but not possible for about 1 - 1.5 hour.
Edited 2024-06-09 21:10 by wiseguy