Inverter building using Wiseguys Power board and the Nano drive board

Author	Message
KeepIS Guru Joined: 13/10/2014 Location: Australia Posts: 1688	Posted: 05:49am 03 May 2024       I realized that two things were missing: 1: I did not have an Inverter DC input over voltage setting - actually really important. 2: I've often worried about having a feedback connection or component fault that might possibly cause the Inverter AC output to go really high, so I've added both options to the code. BTW, don't take any notice of the settings, they are set to cause the inverter controller to trip at lower voltages for testing and verifying the LCD information for trip condition is correct.     Unless someone comes up with an option they think I missed, this is the final addition to my build of the controller code.   FYI The AC relay enable can be set to AUTO (0) = Enable AC relay at the completion of SPWM ramp up. . Edited 2024-05-04 15:57 by KeepIS