Inverter building using Wiseguys Power board and the Nano drive board

Author	Message
Godoh Guru Joined: 26/09/2020 Location: Australia Posts: 458	Posted: 11:57pm 06 May 2024       Thanks Mike, then I will have to look at another way of doing it. Not worth using a kilovac then. I am feeding around 75 to 90 volts into the regulators and up to 35 amps, so maybe just a voltage sensing circuit, then a automotive relay wired into the input of each regulator would do. I could wire the relays through the normally closed contacts that way the relays would only use power when there is a problem. Cheers Pete