Inverter building using Wiseguys Power board and the Nano drive board

Author	Message
KeepIS Guru Joined: 13/10/2014 Location: Australia Posts: 1768	Posted: 07:35am 07 Jun 2024       One thing I forgot to mention when using a LM7805 regulator, it requires a 0.1uf across the output and a 0.33uf across the input, I always solder these across the Regulator pins on the bottom of the board, there is room for a small 220uf or 330uf on the output side, two mounting holes are available on the board. I'm sure Mike (WG) will advise you on his preferred mounting, components and layout in his Thread. .