Inverter building using Wiseguys Power board and the Nano drive board

Author	Message
KeepIS Guru Joined: 13/10/2014 Location: Australia Posts: 1768	Posted: 01:21am 08 Jun 2024       A final DSO image of the 5v rail as inverter is powering down. Test caps I had on the LCD plugs are of course removed.   I removed the Controller, added a small 1000uf to the output of the 7805 linear regulator, and added a 220uf to the input (across the 12v). Both simply solder into the existing holes next to the 7805 very neat, no mods, no tracks touched. If you get a small SMPS regulator this clean then go for it, but if not, I think the simple 7805 change and the supervisor IC mod will give you all the peace of mind you are seeking.   .