Inverter building using Wiseguys Power board and the Nano drive board

Author	Message
KeepIS Guru Joined: 13/10/2014 Location: Australia Posts: 1729	Posted: 10:27pm 29 Jun 2024       There are a few ways, creative bending of the Vo and Gnd pins. Or bend Vo back at 90° and cut short, a small wire from Vo to Vo pad, similar to what I did for the CTRL pin with the Zener and 1.2k, using spare ground and 12v pcb holes. And obviously the way Mike did it, but I wanted to use the breadboard area for a two Pin plug / socket for DC O-C trip input, instead of using the PCB pin for same. .