Inverter building using Wiseguys Power board and the Nano drive board

Author	Message
KeepIS Guru Joined: 13/10/2014 Location: Australia Posts: 2018	Posted: 01:51am 13 Jul 2024         KeepIS said   I was correct about cutting the Mylar tape first, I also use a chisel to cut/break off the green plastic base plate them out No need to remove the green plastic, two pieces of timber against the plastic, not fully under the Toriod, one hit and it just popped out after scoring the Mylar tape. Tried one without first cutting the tape and 4 big hits later, not moving, cut tape, one hit and it popped out. All 3 are done. A 1.2kw toroid next to the 3 for comparison, plugs are gone. _ Edited 2024-07-13 11:59 by KeepIS