Guru
Joined: 13/10/2014
Location: AustraliaPosts: 1860
| Posted: 08:18am 15 Aug 2024 |
I have been dreading cutting out the front panel, so I made a timber template first and mirrored it on the front panel at each end as a cutting guide, I had planned a day (tomorrow) for doing this because of how careful I have to be with it.
But a few hours this afternoon and it's almost ready, the fancy color lettering overlay will be made and fitted after the inverter is fully tested, just in case I need another LED or switch added. A quick test fit and everything is aligned and fits perfectly.
Now only two small Heat-sink temperature meters, a power switch, reset switch and LEDS, and I can wire this up for the Nano controller and other Sensors.
BTW The front panel does not require any holding screws because of the way it's recessed in opening, the handles allow it to be lifted out and placed on top in an instant. This is just so easy to work on.
_
Edited 2024-08-15 18:19 by KeepIS