Guru
Joined: 13/10/2014
Location: AustraliaPosts: 1858
| Posted: 01:40am 16 Feb 2025 |
I was looking at the Photos of Aarons build (Revlac) and I noticed I still has not updated the top line of the Inverter LCD display.
I've just done that on both Dual and Single versions of the Code and download has been just updated. No other changes.
I felt that indicating when SPWM drive was enabled was more important to me than an indication of the Start/Stop request flag which was either ON or OFF, especially since any error that could inhibit the inverter Start/RUN cycle is clearly indicated on the LCD, there are around 18 fault condition messages and that's not including the various LCD I-O status indications.
Full Zip with Nano Info
Just Hex files
Just an FYI update, I have uploaded updated zips with a lot more information for the settings in the Battery Menu options block:
8: Battery <-> Cap delta:
9: Battery low-V disable:
A: Battery low-V timeout:
B: Battery low-V restart:
C: Battery restart delay:
D: Battery HighV disable:
The new file in the Zips is called "Menu Battery Settings.pdf"
.
Edited 2025-02-23 10:58 by KeepIS