Newbie
Joined: 17/07/2024
Location: AustraliaPosts: 6
| Posted: 10:22am 29 Jul 2024 |
Thank you Mike,
I was tossing up where to ask. Here or KeepIS. I appreciate your time is currently tight and I’m not in a rush. Two weeks already passes too fast for me.
While posting remembered the combined freight option and left the note to insure being found before I forget. I have not been off the block to purchase a diary this year.
I too will also be after 100x HY608W plus the other bit listed in the board BOM’s.
Having components mounted also attracted free post? Something in return for using the slowest post option?
Not signing in I to forget to set the country and US$ to AU$.
Also had to be careful confirming links remained under the company umbrella. There were other cloned sites trying to grab your order. Always having to check the hpps address remained correct.
Ply test and repair board.
Ready to test and doing the ply board test and repair station first for once. Once an inverter is up and going in its box, like manuals, left to last and never get Rountuit.
Shuffling bits around, arranging for safe access and measuring without reaching over 240v bits. The Oz control needs a hard cover over the Vfb transformer and its 240v connection. One 240volt bite as a kid was enough. Plenty of RF burns; there like pushing a pin into your finger tip and hitting the bone. Teaches you to keep hands in pockets and not point in transmitter rooms.
Ensuring leaving room for your FET board noticed images KeepIS had posted would exceed the 260mm x 108mm.
I had read the insulator spaces were removable and would be using. (Well done, good foresight planning ahead)
I still have 6 months lead time to complete my in depth drill down of your boards. Comprehending variations in design bringing the FET’s to a safe start /stop sparks interest.
Regards
Mick