Senior Member
Joined: 11/11/2021
Location: United StatesPosts: 122
| Posted: 06:51pm 11 May 2024 |
If FET's are blowing without a load consistently then it's possible the dead-time is too short for the FET's. Perhaps you should set the dead-time on the egs002 to max for now. It's difficult to know for sure unless you can scope the uppper and lower FET's simultaneously.
Also, be aware that, unlike the common usage of egs002 on this forum, you are using it for direct high voltage switching which is risky given that there is not adequate creepage and clearance between the high and low voltage pins.
Edited 2024-05-12 04:52 by analog8484