Admin Group
Joined: 31/12/2012
Location: New ZealandPosts: 9771
| Posted: 01:21am 08 Jul 2024 |
Yes, I had three boards that would not start from my last batch.
Following Peter's advise after he played with the board I sent him, I simply removed C54 and C55 from the other two boards I had here that would not start, then they started up just fine.
Standard firmware.
I will most likely simply leave these caps off the BOM for the next batch of boards, or substitute a lower value that Peter suggested to me during our emails.
But so far three out of three boards that would not start, started just fine if you remove the two load caps, so I will probably get at least some boards made with those caps simply left off and see how we go.
