Guru
Joined: 05/11/2021
Location: GermanyPosts: 464
| Posted: 07:06pm 15 Apr 2024 |
I have been using the WebMite in my home automation system for several months now to read the "analogue" gas meter with magnetic contact via reed contact. The pulses are then sent via MQTT to my broker in the Home Assistant. This works quite stable, except that the WLAN must not fail.
But my question was, which FW do I need for the ESP-01? Doesn't the CMM2 need to respond to the terminal connection or request from my PC with terminal software and isn't this directly included in the CMM2 FW? Or is for that the standard FW with AT commands for the ESP-01 sufficient?
The manual is quite unspecific in this respect. And I can't find the right entries with the forum search :-(
Matthias