Admin Group
Joined: 31/12/2012
Location: New ZealandPosts: 9561
| Posted: 06:17am 19 Apr 2024 |
Thanks for the continued posts to try to help me with this - I appreciate you all very much.
Here is a short(one minute) video with the MM2 chip hooked up to LED's on the pins used for the LCD - everything seems just fine....
Wee video....
I will try the 10nF on the RESET line, and then I will try disconnecting it from the MM2, and pulling it high with a resistor.
...but I expect that MMBASIC uses the RESET pin.....to reset the LCD panel when needed.
The saga continues!
