Good money after bad - Solar upgrade time


Author Message
wiseguy

Guru

Joined: 21/06/2018
Location: Australia
Posts: 1336
Posted: 09:16am 29 Apr 2025      

I have seen and experienced this exact phenomena, I consider it to be a nuisance type issue. I put it down to random probably nano/pico second differences in the nano just executing the code. If enough of these slight perturbations occur in the same direction ie always on the positive cycles the Toroid Flux wanders towards (very mild) saturation on one side of the half cycles but eventually it slowly wanders back the other way. Sometimes there is no noise for multiples of minutes, even tens of minutes but it is never gone.  The corresponding slight increase in current during the mild saturation would also be expected. The reason this does not continue on to become a real issue is that the slight error causing it means there is not enough energy in the error to put it into greater saturation.

Note a toroidal transformer in an amplifier or similar device can make a hell of a "boing" sound followed by a few cycles of hum that decreases rapidly, if you catch it on the wrong part of the cycle after a turn off turn on event.  I mention this to illustrate that the tendency of a transformer is to try to reach a level of equilibrium after an upset, maybe the AC has a natural tendency to demagnetise & remove any saturation naturally.

The Power PCB FET holes were made to accommodate a standard 3.6mmOD TO220 Bush, and with the long necked variety yes the bush shoulders continue into the TO247 FET hole. Something similar to the Digikey part 12SWS0400, it is better not to have to drill out the circuit board plated through holes....
Edited 2025-04-30 00:10 by wiseguy