micromite pwm commands


Author Message
matherp
Guru

Joined: 11/12/2012
Location: United Kingdom
Posts: 10215
Posted: 06:45pm 14 Jun 2024      

  Quote  When you stop the pwm, the pin is also disconnected


This is the same for all I/O modes : I2C, SPI, PWM, UART
When you close the usage the pins are released back to unallocated

This is how it is intended so as Volhout says if you set the PWM to OFF you will need to SETPIN the pins again to re-use for PWM